Spoolsw; Ssdp - Gestetner P7245 Hardware Manual

Monitoring and Configuring the Printer

spoolsw

Use the "spoolsw" command to view and configure Job Spool settings.
You can only specify diprint, lpr, ipp, ftp, smband sftp protocol.
• The "spoolsw" command for configuring Job Spool settings is available only
when the optional hard disk is installed.
❖ View settings
The Job Spool setting appears.
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable Job Spool, or "off" to disable it.
5
❖ Resetting Job spool setting
msh> spoolsw clear job {on | off}
• When the printer power is cut during job spooling, this determines wheth-
er to reprint the spooled job.
❖ Protocol configuration
msh> spoolsw diprint {on | off}
msh> spoolsw lpr {on | off}
msh> spoolsw ipp {on | off}
msh> spoolsw smb {on | off}
msh> spoolsw ftp {on | off}
msh> spoolsw sftp {on|off}
• You can specify the settings for diprint, lpr, ipp, smb and sftp.

ssdp

Use the "ssdp" command to view and configure SSDP settings.
❖ View settings
msh> ssdp
❖ Setting effective time
msh> ssdp profile {1801–86400}
The default is 10800 seconds.
❖ Advertise packet TTL settings
msh> ssdp ttl {1–255}
The default is 4.
208