Extreme Networks ISM Provision User Manual page 63

Summary Steps. To modify a configuration object:
1 Select the object to modify
2 Launch the Modify wizard (Edit>Properties)
3 Edit the object properties
4 Select Finish
Detailed Steps. The following steps are a more detailed explanation of the previous
section.
To modify a configuration object:
1 Select the object to modify
Display the object you wish to modify and select it by left-clicking. See the section
"View a Single Configuration Object" for detailed information on displaying
(viewing) an object. For some objects, you may need to select its parent object
instead. For example, to change which modules are configured in a device, you
might try to select the Modules object and modify it. However, you cannot modify
which module is configured from this object. You will need to select the parent
device object to modify which module is present in a slot.
2 Launch the Modify wizard (Edit>Properties)
To launch the Modify wizard, select the menu item Edit>Properties. You can also
launch the Modify wizard by right-clicking on the object and selecting Properties
from the pop-up menu, or you can launch it by typing [CTRL]+E. The Modify
wizard that appears is dependent on the object you are modifying. For example, if
you are modifying a VLAN, the Modify VLAN wizard appears. If you are
modifying a device, the Modify Device wizard appears (see Figure 4-18).
Network Infrastructure Manager User Guide
Create and Modify Network Device Configurations
4-27