Disposal; Parts List - Flowserve Valtek FlowTop V726 User Instructions

Valtek FlowTop
Special Tool

17 Disposal

Up to 95 % of the FlowTop control valve is metal. The remain-
ing materials are synthetic, rubber, polytetrafluoroethylene
(PTFE), graphite, paint, and lubricants.
The valve should be professionally disassembled and reas-
Potential hazards and their sources are under the operator's influence. The operator must observe national
NOTICE
and international environmental conditions for control valve removal from the pipeline and cleaning. Permis-
sible limit values must be maintained to ensure suitable protective measures; service personnel must be properly instructed in
performing the disassembly and reassembly procedure.

18 Parts List

Since the implementation would go beyond any scope, refer-
ence is made here to the order documentation. The materials
used can be found in the BOM (bill of material) and the SEC
(sectional drawing).
FCD VLEEIMFTOP-03 (EN/A4) June 2023
Mechanical Torque Multipliers
Recommended tool for disassembling and reassembling.
e.g. Juwel 03L, max. 5 400 Nm, reduction ratio 33:1
Juwel 06, max. 10 000 Nm, reduction ratio 60:1
sembled. Metal parts should be scrapped, with the remaining
materials disposed of according the national conditions.
Peripheral units (accessories) should be recycled according
the relevant manufacturer's User Instructions.
Use
flowserve.com
63