Table of Contents
Advertisement
DES-3228PA Embedded Web System User Guide
Section 7. Configuring Ports
The Interface Configuration Page contains fields for defining port parameters. To define port parameters:
1.
Click Basic Setup > Interface > Interface Configuration. The Interface Configuration Page opens.
Figure 31: Interface Configuration Page
The Interface Configuration Page is divided into the following sections:
•
Interface Configuration ports table
•
Interface Configuration LAG table
The Interface Configuration Ports Table contains the following fields:
•
Unit No. — Displays the stacking member unit number.
•
Interface — Displays the port number.
•
Port Status — Indicates whether the port is currently operational or non-operational. The possible field val-
ues are:
–
Up — Indicates the port is currently operating.
–
Down — Indicates the port is currently not operating.
•
Port Speed — Displays the configured rate for the port. The port type determines what speed setting options
are available. Port speeds can only be configured when auto negotiation is disabled. The possible field values
are:
–
10 — Indicates the port is currently operating at 10 Mbps.
–
100 — Indicates the port is currently operating at 100 Mbps.
–
1000 — Indicates the port is currently operating at 1000 Mbps.
•
Duplex Mode — Displays the port duplex mode. This field is configurable only when auto negotiation is dis-
abled, and the port speed is set to 10M or 100M. This field cannot be configured on LAGs. The possible field
values are:
Page 71
Advertisement
Table of Contents
