Site Requirements; Package Contents; Unpacking Essentials - D-Link xStack DES-3228PA Web/Installation Manual

Layer 2 stackable 10/100mbps ethernet switch with poe
Hide thumbs Also See for xStack DES-3228PA:
Table of Contents

Advertisement

DES-3228PA Embedded Web System User Guide

Site Requirements

Before installing the unit, verify that the location selected for installation meets the following site requirements.
General — Ensure that the power supply is correctly installed.
Power — Ensure that the unit is installed within 1.5 m (5 feet) of a grounded, easily accessible outlet 100-250
VAC, 50-60 Hz.
Clearance — Ensure that there is adequate frontal clearance for operator access. Allow clearance for
cabling, power connections and ventilation.
Cabling — Ensure that the cabling is routed to avoid sources of electrical noise such as radio transmitters,
broadcast amplifiers, power lines and fluorescent lighting fixtures.
Ambient Requirements — Ensure that the ambient unit operating temperature range is 0 to 40ºC (32 to
104ºF) at a relative humidity of up to 95%, non-condensing. Verify that water or moisture cannot enter the
device casing.
Unpacking
This section contains information for unpacking the device, and includes the following topics:

Package Contents

Unpacking Essentials

Package Contents
While unpacking the device, ensure that the following items are included:
The device
Four rubber feet with adhesive backing
Rack kit
An AC power cable
Console RS-232 cable with DB-9 connector
Documentation CD
Unpacking Essentials
Note
Before unpacking the device, inspect the package and report any evidence of damage immediately.
To unpack the device perform the following:
1.
It is recommended to put on an ESD wrist strap and attach the ESD clip to a metal surface to act as ground.
An ESD strap is not supplied with the device.
2.
Place the container on a clean flat surface and cut all straps securing the container.
3.
Open the container.
4.
Carefully remove the device from the container and place it on a secure and clean surface.
5.
Remove all the packaging material.
6.
Inspect the product for damage. Report any damage immediately.
If any item is found missing or damaged, please contact your local D-Link reseller for replacement.
Page 17

Advertisement

Table of Contents
loading

Table of Contents