Table of Contents
Advertisement
DES-3228PA Embedded Web System User Guide
The following message is displayed.
Write Flash file name (Up to 8 characters, Enter for none.):config File config (if
present) will be erased after system initialization
========Press Enter To Continue ========
3.
Enter
as the name of the flash file. The configuration is erased and the device reboots.
config
4.
Perform the switch's initial configuration.
Erase FLASH Sectors
For troubleshooting purposes, the flash sectors may need to be erased. If the flash is erased, all software files
must be downloaded and installed again.
To erase the FLASH:
1.
From the Startup menu, press "3" within 6 seconds. The following message is displayed:
Warning! About to erase Flash Memory! FLASH size =16252928.blocks =64 Are you sure (Y/
N)
2.
Confirm by pressing
Enter First flash block (1 -63):
3.
Enter the first flash block to be erased and press
Enter Last flash block (1 -63):
4.
Enter the last flash block to be erased and press
Are you sure (Y/N)
5.
Confirm by pressing
Erasing flash blocks 1 -63: Done.
Password Recovery
If a password is lost, use the Password Recovery option on the Startup menu. The procedure enables the user to
enter the device once without a password.
To recover a lost password for the local terminal only:
1.
From the Startup menu, select "4
2.
To ensure device security, reconfigure passwords for applicable management methods.
. The following message is displayed:
<Y>
. The following message is displayed:
<Y>
and press
"
<Enter>
. The following message is displayed:
<Enter>
. The following message is displayed:
<Enter>
. The password is deleted.
Page 37
Advertisement
Table of Contents
