Attaching The Embroidery Frame To The Embroidery Arm; Removing The Embroidery Frame From The Embroidery Arm - Brother PC-6500 Operation Manual

Attaching the embroidery frame to the embroidery arm

CAUTION
Be sure to wait until the embroidery unit has finished initializing before trying to attach the
embroidery frame. (Refer to page 87.)
1

Removing the embroidery frame from the embroidery arm

1
92
1. Raise the presser foot lever to its highest position, and then
pass the embroidery frame under the presser foot, making
sure that the mounting bracket of the frame is on the left
side and the right side of the fabric is facing up.
2. Align the slots in the mounting bracket of the frame with the
two knobs on the frame holder of the embroidery arm, and
then press the frame onto the frame holder so that it clicks
2
into place.
1 Frame holder on embroidery arm
2 Knobs
Note
Be sure that the mounting bracket on the embroidery frame is
attached to both knobs. If it is attached to only one knob, the
pattern may not be embroidered correctly.
While pushing the release lever on the frame holder to the left,
lift the embroidery frame up to remove it.
1 Release lever