Embroidering; Setup; Installing Embroidery Foot Q - Brother PC-6500 Operation Manual

EMBROIDERING

SETUP

Installing embroidery foot Q

CAUTION
Be sure to turn off the power before attaching embroidery foot Q. If the power is left on and the start/stop
button is accidentally pressed, the machine will start operating, which could result in serious injury.
86
1. Press the needle position button to raise the needle, and
5
then turn off the sewing machine.
2. Raise the presser foot lever.
3. With the enclosed screwdriver or disc-shaped screwdriver,
loosen the screw on the presser foot holder, and then pull
the holder downward to remove it.
1 Presser foot holder
5
4. Slide the bracket on embroidery foot Q up onto the presser
foot bar, and then fasten it by firmly tightening the screw
with the enclosed screwdriver or disc-shaped screwdriver.
1 Embroidery foot Q
CAUTION
Be careful not to touch the tip of the needle, otherwise
injuries may occur.
Note
– Make sure that embroidery foot Q is tightly attached to the
presser foot bar.
– It is recommended that a 90/14-size needle be used when
embroidering thicker fabrics such as denim or when using
stabilizing products such as puffy foam. A 75/11-size needle
might bend or break, which could result in injuries.
CHAPTER 5