Installing The Bobbin - Brother PC-6500 Operation Manual

Installing the bobbin

2
1
(a)
1. Slide the bobbin cover latch to the right, and then remove
the bobbin cover.
1 Bobbin cover latch
2 Bobbin cover
1
2. Insert the bobbin into the shuttle so that the thread unrolls
as shown in the illustration.
3. Guide the thread through the groove, then pull the thread
toward you to cut off any excess.
1 Built-in thread cutter
4. Reattach the bobbin cover by inserting the left end (a) and
pressing down lightly on the right end so that it snaps into
place (b).
(b)
Note
You can begin sewing without pulling up the bobbin thread.
23