Needle Threader - Brother PC-6500 Operation Manual

Needle threader

1
2
5
2 2
1
Needle Thread (cotton)
65/9
75/11
90/14
100/16
26
1. Use your left index finger to lower the needle threader lever
while gently pulling the thread to the left so that it catches on
the large hook.
5
1 Needle threader lever
2 Large hook
3
2. Lower the needle threader lever to its lowest position and
check that the thread is held by the large hook and that the
small hook has passed through the eye of the needle.
1 Small hook
3. Pull the thread through the guides on each side of the
needle so that the thread catches on the hook that passes
through the eye of the needle.
2 Guides
4. While gently holding the thread, raise the needle threader
lever.
5. Pull the thread through the eye of the needle out towards
the rear of the machine.
5
6. Pass the thread underneath the presser foot, and then pull
about 2" (5.0 cm) of the upper thread out toward the rear of
the machine.
Note
You can begin sewing without pulling up the bobbin thread.
Note
– The needle threader cannot be used with the needle and
#30, 50, 60
thread combinations shown at the left.
#30
– The needle threader can be used with transparent nylon
thread and any size needle between 90/14 and 100/16.
#30
#20