Table of Contents
Advertisement
2
Chapter
Embroidering Preparation
Follow the steps below to prepare the machine for
embroidery.
Step 2
Step 1
Step 5
Step 4
Step
Aim
#
1
Checking the
It is recommended to use a
needle
75/11 home sewing machine
needle.
2
Embroidery unit
Attach the embroidery unit.
attachment
3
Bobbin thread
For the bobbin thread, wind
setup
embroidery bobbin thread and
set it in place.
4
Fabric
Attach a stabilizer material to
preparation
the fabric, and hoop it in the
embroidery frame.
5
Embroidery
Attach the embroidery frame
frame
to the embroidery unit.
attachment
6
Pattern selection Turn the main power to on,
and select an embroidery
pattern.
7
Checking the
Check and adjust the size and
layout
position of the embroidery.
8
Embroidery
Set up embroidery thread
thread setup
according to the pattern.
EMBROIDERY
Step 8
Step 6, 7
Step 3
Action
Page
18
19
11
21
23
24
25
26
Attaching the Embroidery Unit
CAUTION
• Before attaching the embroidery unit, be sure
to turn off the machine. Otherwise, injuries
may occur if one of the operation buttons is
accidentally pressed and the machine starts
embroidering.
• Do not move the machine with the embroidery
unit in place. The embroidery unit may be
dropped and cause injury.
• Keep your hands and other objects away from
the embroidery carriage and frame when they
are moving. Otherwise injury may result.
Turn off the machine.
a
Insert the embroidery unit connector into the
b
connection port, and then lightly push in the
embroidery unit until it snaps into place.
c
b
Note
• Make sure that there is no gap between the embroidery
unit and the machine, otherwise the embroidery pattern
may not be embroidered correctly. Be sure to fully insert
the connector into the connection port.
• Do not push on the carriage when attaching the
embroidery unit to the machine, otherwise damage to
the embroidery unit may result.
• Do not touch the connector in the embroidery unit
connector slot. The connector could be damaged, and it
may cause malfunctions.
• Do not lift up on the embroidery carriage, and do not
forcefully move it. It may cause malfunctions.
c
Turn on the machine.
A message appears in the screen.
Note
• If [Opening Screen] is set [ON] within the settings
screen, touch screen for the following message to
appear.
Embroidering Preparation
1 Connection port
2 Embroidery unit
connector
3 Carriage
a
19
2
Advertisement
Table of Contents
