CYBEX Arc Trainer 770A Service Manual page 55

Remove incline motor
Remove grooved pin securing incline motor to main frame.
Remove incline motor.
Install new incline motor
Place new incline motor in position. Verify center of holes is equal to 10.50" (27 cm).
Install a retaining ring to one side of grooved pin using a 1/2" ID external retaining-ring tool or
plier.
Install grooved pin securing the new incline motor to drive frame assembly.
Install a retaining ring to other side of grooved pin using a 1/2" ID external retaining-ring tool or
plier.
Retaining
Ring
(27cm)
Retaining
Ring
55
Grooved
Pin
Incline
Motor
Grooved
Pin
Incline
Motor