Endless Pools FASTLANE PRO Owner's Manual page 13

On the inside of the pool, thread the sacrificial 3/8" (9,5mm) steel (with rubber washer) and bolt into the
W
hex coupling through the hole that was previously drilled in the steel wall. Tighten the bolt to secure the
assembly (Fig 4.9).
Fig. 4.9
Apply Teflon thread sealant to the threads of the 1/1/2" (38mm) MPT x FSlip adapters and thread them
into the backside of the star thru-wall fittings. Unroll the flexible PVC from the wall mount bracket back to
the hydraulic power unit. Any bends in the flexible PVC should be gradual sweeps and not sharp to allow
the hydraulic hoses to be easily fed through the conduit. Each length of PVC must be no longer than 21ft
(6,4m) and should exit the ground near the hydraulic power unit. Glue the PVC flex pipe into the adapter
and run the pipe back to the power unit (Fig 4.10)
Fig. 4.10
If the distance between the wall mount bracket and the hydraulic power unit is greater than 25ft (7,6m)
then a junction box and additional flex pipe must be employed. In this case, the flex pipe between the wall
mount bracket and the junction box must be 24ft 6in (7,5m). This will allow the hydraulic hose attached to
the Fastlane Pro to terminate just inside the junction box. Refer to section 5 for additional information.
Fastlane Pro Swim Unit Installation
®
12