Endless Pools X2000 SwimCross Owner's Manual
  1. Manuals
  2. Brands
  3. Endless Pools Manuals
  4. Swimming Pool
  5. X2000 SwimCross
  6. Owner's manual

Endless Pools X2000 SwimCross Owner's Manual

Hide thumbs Also See for X2000 SwimCross:
Table of Contents

Advertisement

Quick Links

O W N E R ' S M A N U A L 5 0 H Z
X2000 SwimCross™ System
by Endless Pools
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the X2000 SwimCross and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Endless Pools X2000 SwimCross

Summary of Contents for Endless Pools X2000 SwimCross

  • Page 1 O W N E R ' S M A N U A L 5 0 H Z X2000 SwimCross™ System by Endless Pools ®...
  • Page 2 As a general practice, your local Building Department will inform you of any applicable barrier requirements at the time a permit is obtained for the installation of an electrical circuit. Your ENDLESS POOLS dealer can provide...

  • Page 3: Table Of Contents

    TABLE OF CONTENTS SAFETY INFORMATION INVERT SCREEN ..............19 TEMPERATURE CONTROL ..........19 IMPORTANT SAFETY INSTRUCTIONS ......1 JETS CONTROL ..............19 IMPORTANT EXERCISE SYSTEM INSTRUCTIONS ..3 LIGHT CONTROL ...............20 SITE REQUIREMENTS FILTER CYCLES ..............20 INDOOR CONSIDERATIONS ..........4 POLLING ................20 OUTDOOR CONSIDERATIONS ........4 ALL OFF / MEMORY ON............20 ELECTRICAL REQUIREMENTS ........

  • Page 4: Safety Information

    NO DIVING Safety Information IMPORTANT SAFETY Danger: Diving may result INSTRUCTIONS in serious injury or death. (READ AND FOLLOW ALL audio system unless approved by Watkins Wellness INSTRUCTIONS) • Do not self service the audio component by opening or removing exercise system door panel as this may expose dangerous voltage or other risk of injury.
  • Page 5 DON'T: UNCLEAN WATER • Use the exercise system with the equipment compartment door removed. • Keep the water clean and sanitized with correct chemical care. The • Place electrical appliances within 1.5 m (5 feet) of the exercise recommended levels for your SWIMCROSS exercise system are: system.

  • Page 6: Important Exercise System Instructions

    , Windex or spa Mitt. NEVER USE HARSH CHEMICALS! contact your ENDLESS POOLS dealer. Safety labels that are affixed to Damage to the shell by use of harsh chemicals is not covered under the shell are intended to be permanent and should not be removed.

  • Page 7: Site Requirements

    Should there a be a gap or should the water puddle inside the footprint, will be needed to gain access to components for maintenance and call your ENDLESS POOLS dealer prior to continuing to discuss the general servicing. best way to resolve this situation.

  • Page 8: Deck Installation

    DECK INSTALLATION DELIVERY ACCESS To be certain your deck can support your system you must know It may be necessary to remove a gate, part of a fence, or other movable the deck’s maximum load capacity. Consult a qualified building obstructions in order to move the system to its installation site.

  • Page 9: X2000 Model

    X2000 MODEL *147 cm 10 cm 226 cm 4.5 cm 610 cm ELECTRICAL CUTOUT SWIM DRAIN TOP VIEW OF BASE 15 cm SPA DRAIN 328 cm 267 cm DOOR SIDE 4.5 cm 33 cm ELECTRICAL CUTOUT NOTE: SWIMCROSS requires that the X2000 Model be installed on a minimum 15 cm thick reinforced concrete pad or structurally sound deck able to support the “dead weight”...

  • Page 10: Electrical Requirements

    Electrical Requirements • Open exercise system by removing the 4 screws holding the vertical T-spacer to the left of the equipment compartment (see Door Panel Removal and Replace Instruction on the following IMPORTANT: Fill the exercise system with water before turning on the page).

  • Page 11: Phase (Model) Wiring

    T-spacer located in the center of the equipment compartment IMPORTANT: If you ever need to move or relocate your ENDLESS POOLS exercise system, it is essential that you understand and apply these installation requirements. Your SWIMCROSS exercise system has been carefully engineered to provide maximum safety against electric shock.

  • Page 12: Equipment Compartment

    EQUIPMENT COMPARTMENT The illustrations below are to be used as a reference only (your exercise system may look different). The equipment compartment is located below and to the right of the control panels (spa side of the exercise system). Hydromassage Jets pump Swim Side Jet Pump 11.

  • Page 13: Getting Started

    Getting Started MAIN EXERCISE SYSTEM FEATURES Your exercise system may look slightly different than the illustration 1 ) Two control panels are used to provides a quick visual check of the exercise system’s status and allows the user to set different functions in both the swim and spa sides.

  • Page 14: Hydromassage Jets

    HYDROMASSAGE JETS WATERFALL VALVE Your exercise system is equipped LARGE HYDROMASSAGE Jets - This jet provides a unique, pulsating with three waterfalls, two in the swim massage. The water flow is adjustable in that it can be turned from low side and one in the spa side.
  • Page 15 START-UP • To turn off the jets, press the jets button on the spa side control panel. Your SWIMCROSS exercise system has been thoroughly tested during • If you do not feel a steady stream of water from your jets, refer the manufacturing process to ensure reliability and long-term customer to the instructions for priming the pump in the exercise system satisfaction.

  • Page 16: Operating Instructions

    Operating Instructions WATER CARE / HEATER SETTINGS The Water Care section will help you set The exercise system has two control panels, one controls the up your purge times and heater settings. large swi m side and the other controls the smaller spa side. Choose from Away from Home, Beginner, Energy Savings, Super Energy Savings, SWIM SIDE CONTROL PANEL...
  • Page 17 DATE AND TIME You have several possibilities for the schedule (Mon-Fri, weekend, Here you can adjust the time format, every day, or single days). The change the year, date, and time. schedules will be repeated every Use the buttons to choose week.

  • Page 18: Audio In.stream 2 (Optional)

    AUDIO IN.STREAM 2 (OPTIONAL) (85°F) the first time power is applied. This is the setting programmed at the factory. After the exercise system has been set up and used, the If your exercise system has the optional in.stream 2 Bluetooth last temperature value set by the user will be stored in memory.

  • Page 19: Light Control

    LIGHT CONTROL PURGE CYCLES All exercise systems are equipped When your exercise system is first powered up, the default purge cycle with a lighting system. This system is set to start at 12:00 pm turning each swim jet pump on for 1 minute includes a main interior light inside using the Beginner Water Care mode.

  • Page 20: Spa Side Control Panel

    SPA SIDE CONTROL PANEL WATER CARE The Water Care section will help you The spa side control panel provides a bright, full color display, and set up your ideal filtration and heating intuitive user experience, while its screen’s high resolution brings settings.
  • Page 21 KEYPAD SETTINGS You have several possibilities for the schedule (Mon-Fri, weekend, In this section, you can change the every day, or single days). The temperature unit, language, display schedules will be repeated every orientation, rim control panel light week. Once you have set the color, and lock the control panel.

  • Page 22: Invert Screen

    TEMPERATURE CONTROL WI-FI (OPTIONAL) This menu allows you to connect The set temperature range is from 15°C to 40°C (59°F to 104°F). (The your in.touch module to a Wi-Fi water temperature of the spa side may rise or lower slightly depending network or to change its network.

  • Page 23: Light Control

    LIGHT CONTROL ALL OFF / MEMORY ON All exercise systems are equipped with a lighting system. This system Press the (middle right) button includes interior points of lights located when in the home screen to turn the throughout the spa side. lights and any jets that are on OFF.

  • Page 24: Water Quality And Maintenance

    Turn swim jets ON, run for 10 minutes and turn OFF. often you use your spa, and how many people use it. Check with your ENDLESS POOLS dealer to determine if water in your region has Carefully measure the recommended amount of chemical and...

  • Page 25: The Swimcross Water Maintenance Program

    so that they are stabilized or balanced. Balance the water chemistry of calcium hardness (soft water) can increase foaming. Although every time you fill the exercise system with new water and then during ozone can oxidize soap residual, it may become necessary to add the life of that body of water.
  • Page 26 how much sanitizer to add in order to maintain the proper residual. If the use in exercise systems and swimming pools. It is extremely important usage pattern increases dramatically with invited guests, the amount to choose one specifically designed for exercise systems. Use of an and frequency of sanitizer required will also increase.

  • Page 27: Vacation Water Care Instructions

    In-line the blockage. pre-filters can be purchased at your local ENDLESS POOLS dealer. Reinstall the tubing to the bottom of the ozonator. Foam Inhibitors...

  • Page 28: Care And Maintenance

    chloramines, and will not alter the water’s pH. Pull the filter grate from the bottom up until it unlocks from pH: The measure of the exercise system water’s acidity and alkalinity. the wall. ppm: The abbreviation of “parts per million”, the standard measurement IMPORTANT: ONLY of chemical concentration in water.

  • Page 29: Spa Side Filter Cartridge Removal Instructions

    Drain Cap Locate the drain valves located outside. If you have any questions regarding precautions to take (bottom, lower right of control with against freezing, please call your ENDLESS POOLS Dealer. panels) for the exercise Handle CARE OF THE PILLOWS system.

  • Page 30: Care Of The Exterior

    Iron and copper in the water can stain the exercise system shell if allowed to go unchecked. Ask your ENDLESS POOLS dealer about a Stain and Scale Inhibitor to use if your exercise system has a high concentration of dissolved minerals.

  • Page 31: Service Information

    Service Information • High temperature: All SWIMCROSS exercise system models are equipped with a jet pump shroud that vents the heat generated by the pump motor to the outside of the equipment compartment, and back GENERAL INFORMATION into the exercise system water. If the vent is blocked by masonry, grass or debris, overheating of the jet pump may occur.

  • Page 32: Disclaimers

    ENDLESS POOLS dealer. necessity for crane removal. Any implied warranty shall have a duration equal to the duration of the applicable limited warranty stated above.
  • Page 33 • Let cool for one hour. Motor overload will reset automatically. If problem persists, contact your ENDLESS POOLS dealer • Disconnect exercise system and contact your ENDLESS POOLS dealer • Control switch failure if jet symbol does not come on Noisy pump or motor •...
  • Page 36 CAUTION: Watkins Wellness suggests a structural engineer or contractor be consulted before the exercise system is placed on an elevated deck. Ask your ENDLESS POOLS dealer for more information. ©2018 WATKINS WELLNESS. ENDLESS POOLS is a trademark of WATKINS WELLNESS, registered in the U.S., Canada, CTM and other countries. Watkins Wellness EU Siemenslaan 10 B-3650 Dilsen –...

Table of Contents