Safety Precautions - AXIOMTEK ICO520 Series User Manual

Safety Precautions

Before getting started, please read the following important safety precautions.
1. The ICO520 does not come equipped with an operating system. An operating
system must be loaded first before installing any software into the computer.
2. Be sure to ground yourself to prevent static charge when installing the internal
components. Use a grounding wrist strap and place all electronic components in
any static-shielded devices. Most electronic components are sensitive to static
electrical charge.
3. Disconnect the power cord from the ICO520 before making any installation. Be
sure both the system and the external devices are turned OFF. Sudden surge of
power could ruin sensitive components. Make sure the ICO520 is properly
grounded.
4. Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
5. Turn OFF the system power before cleaning. Clean the system using a cloth only.
Do not spray any liquid cleaner directly onto the screen.
6. Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -45°C or above 85°C. It may damage the equipment.
7. Do not open the system's back cover. If opening the cover for maintenance is a
must, only a trained technician is allowed to do so. Integrated circuits on
computer boards are sensitive to static electricity. To avoid damaging chips from
electrostatic discharge, observe the follo wing precautions:
▪
Before handling a board or integrated circuit, touch an unpainted portion of
the system unit chassis for a few seconds. This will help to discharge any
static electricity on your body.
▪
When handling boards and components, wear a grounding wrist strap,
available from most electronic component stores .
8. Warning:
Replacing the battery with an incorrect type can result in an explosion risk.
Dispose of used batteries according to the instructions.
9. Caution:
Do not touch the surface of the unit, which can become quite hot during operation.
Restricted access area: The equipment should only be installed in a restricted
access area.
10. 10. This product is intended to be supplied by a Listed Power Adapter or DC power
source, output meets SELV, rated 12-24Vdc, minimum 4.01A -1.01A, Tma = 50
degree C, and the altitude of operation = 2000m.
If you need further assistance while purchasing the power source, please contact
the manufacturer for further information.
iii