Megarac G2 Card Management; Remote Control - American Megatrends MegaRAC G2 User Manual

MegaRAC G2 Card Management

You can left click on the Management section button to remotely control and redirect
your MegaRAC G2 card and host system. This is the most powerful feature of the
MegaRAC G2 card. These functions are divided into two subsections. The following
table gives you a brief description of each. Each subsection is explained in more detail
further in this section.
Function
Remote
Control
Remote
Console
Crash Screen

Remote Control

The Remote Control screen is a subsection of the Management group. The buttons in this
subsection generate the following results:
Button
Reset
Power Down
Power Up
Power Cycle
Reset MegaRAC
Note: Sometimes resetting the host system cannot solve your given problem. In such cases,
power cycling the host system may overcome the problem.
Icon Description
This page allows you to control the host system through a hardware
reset or power cycle.
This page allows you to remotely operate the host system's
keyboard and mouse during a video redirection.
This page allows you to view the last screen before a cold boot.
This is useful in the event that the host system locks up or freezes.
Description
Generates a hardware reset signal on the host system.
Powers up the host system.
Powers up the host system.
Automatically generates power down followed by a power up
sequence with a pre-specified delay.
Resets the MegaRAC G2 card's on-board firmware.
Chapter Four : Using Your MegaRAC G2 Card 59