Modem Daughterboard Installation - American Megatrends MegaRAC G2 User Manual

Before You Start,
Continued
Avoid Electro-Static Discharge (ESD), Continued
Perform all unpacking and installation procedures on a ground-connected anti-static mat.
Wear an anti-static wristband grounded at the same point as the anti-static mat. You can
also use a sheet of conductive aluminum foil grounded through a one megaohm resistor
instead of the anti-static mat. Similarly, a strip of conductive aluminum foil wrapped
around the wrist and grounded through a one megaohm resistor serves the same purpose
as a wristband.

Modem Daughterboard Installation

The MegaRAC G2 modem daughterboard is an optional component. Use the following
steps to install the modem daughterboard onto the MegaRAC G2 card.
Step Action
1 Unpack the modem daughterboard.
2 Locate JP4 on the MegaRAC G2 card. It has a series of pinholes that allow you to insert the modem
daughterboard. Match the modem daughterboard and the pin holes so that the pins align properly. Insert
the modem daughterboard by sliding it straight down into the MegaRAC G2 card. See the illustrations on
the following page.
MegaRAC G2
Note: If the
MegaRAC G2
and
MegaRAC G2
3 Plug in the MegaRAC G2 card into the host system and attach internal cables
4 Connect external cables
Note: For the complete
Management Card
Note: Inspect the cardboard carton for obvious damage.
142 MegaRAC G2 User's Guide
card is already installed into a host system, power down the host system
card first. Physically unplug all external and internal cables from the
MegaRAC G2
card. Remove the
MegaRAC G2
card installation procedures, see your
User's Guide located on the
card from the host system.
MegaRAC G2 Remote
MegaRAC G2 CD
.
Cont'd