American Megatrends MegaRAC G2 Install Manual

Quick Hardware Installation Guide
MegaRAC™ G2
Battery Backup Unit
(for Series 827)
Thank you for purchasing the MegaRAC™ G2 Battery Backup Unit.
Please take a few minutes to review this quick guide before beginning
the installation process.
Unpack the MegaRAC G2 Battery Backup Unit
and Battery Clip
Inspect the cardboard carton for obvious damage. If damaged, call
770-246-8600. Leave it in its original packing. Perform all unpacking
and installation procedures on a ground-connected anti-static mat.
The MegaRAC G2 battery backup unit is an optional component.
When the optional battery is installed, your MegaRAC G2 card can
stay powered on for 30 minutes without any external power from the
host system or AC adapter.
To install the Battery Backup Unit, plug the battery cable into the J1
connector and place the battery pack in between the three mounting
holes. Next, align and snap the plastic battery clip into the three
mounting holes over the battery pack. See the diagram on the right.
Charging the Battery Backup Unit
WARNING!
Risk of explosion if battery type used is incorrect.
ONLY use American Megatrends battery part number BAT-
The Battery Backup Unit is shipped uncharged. The MegaRAC G2
card automatically starts to charge the battery after you install it. You
must charge the battery pack before it can be used to provide backup
power to the MegaRAC G2 card.
MAN-BBU-QH
LIION-3.6-01.
Contents for the MegaRAC™ G2 Battery Backup
Unit
02-20-03
You should have received the following:
•
one MegaRAC™ G2 Battery Backup Unit (BAT-LIION-3.6-01)
•
one battery clip
•
this MegaRAC™ G2 Optional Battery Quick Installation Guide

Technical Support

If you need help installing or configuring the MegaRAC G2 Battery
Backup Unit, call American Megatrends technical support at 770-
246-8645.
Technical Support Web Site: http://www.ami.com/support/
Technical Support Email: support@ami.com

Hardware Installation

Following the steps in this guide to install the MegaRAC G2 Battery
Backup Unit.
Note: Inspect the cardboard carton for obvious damage. If
damaged, call 770-246-8645. Leave the MegaRAC G2 Battery
Backup Unit in its original packing.
Diagram
Plug the battery cable
into the J1 connector
Place the battery
in between the three
mouniting holes
English
Align and snap
the battery clip
into the three
mounting holes
on top side of
the PCB over the
battery backup
unit