Step 10 Connect To The Megarac G2 From A Client System - American Megatrends MegaRAC G2 User Manual

Step 10 Connect to the MegaRAC G2 from a Client System

In order to connect to the MegaRAC G2 card, you must access the MegaRAC G2 from
another system on the same network. This document refers to this other system as the
client system. To do this, you must know the MegaRAC G2 card's IP address. If you
have installed the MegaRAC G2 on a network that uses DHCP, you can search the
network for the MegaRAC G2 card. To locate and find out its IP address, you must install
and run G2Seek.
Note: To get or set the IP address on your MegaRAC G2 card in a Windows 2000/XP
environment, you can also run the G2ConfigApp program on the host system. See
Appendix B, WinCuri, LinCuri, and G2ConfigApp for more information on how to use
the G2ConfigApp program.
Follow the steps in the table below to connect to the MegaRAC G2 from a client system:
Step Description
1
On a local network computer, place the MegaRAC G2 CD into the CD-ROM drive. Locate the G2Seek
program on your MegaRAC G2 CD Disc. It is located in the following directory:
CDROM\RemoteTools\Win32\G2Seek.exe
Run the G2Seek program by double left clicking on it.
2 Left click on the Next button when you see this screen.
G2Seek.exe
Chapter Two : Installing Your MegaRAC G2 Card
Cont'd
19