Memory Channels - Icom IC-820H Instruction Manual

29
8 MEMORY MODE
i Memory channels
The transceiver has a total of 100 memory channels. 50 channels are assigned to each band _ initially.
Each memory channel can be used to store often- However, these can be allocated between bands for
used frequencies and operating modes as well as a a maximum of 80 channels in one band. (in this
tone frequency, offset frequency, etc. case, 20 channels for the other band).
Memory mode
VFO mode
(Adsed
Push
This can be
increased
Scan edge
channels
ma Operation on a memory channei
e Frequency and mode, etc. can be changed in a e Memory channel 6 and channels above have no
memory channel. However, they will be cleared if contents programmed. The following indication
[MW] is not pushed. appears after 2 sec. when selecting these chan-
nels.
When selecting non-
The previous contents MEMO programmed chan-
in memory channel 50. Litt nels.
: After 2 sec., the dis-
pee Cena 42379 MEMO play shows the as-
frequency ote, EET Coa
4 944, eB signed band.
@ A beep tone sounds when changing the memory
When [MW] is pushed channel. 2 beep tones sound when scan edge
in the above step, channels are selected to distinguish the end of the
select ch 50 memory channels.
When [MW] is not pushed
in the above step, select
ch 50 again.
Previous contents
appear.
The changed contents
appear.