Transferring Memory Contents - Icom IC-820H Instruction Manual

31
8 MEMORY MODE
@ Transferring memory contents
This function transfers the memory channel contents
into a VFO. This is useful to call up the subaudible
tone frequency, offset frequency, etc., to the VFO.
Y NOTE: When you have changed the frequency and
mode in the selected memory channel:
- Displayed frequency/mode are transferred.
- Programmed frequency/mode are not transferred,
and they remain in the memory channel.
@) Push [MEMO] to select the memory mode.
- This function cannot be activated from the VFO
mode.
(2) Select a memory channel with the [DOWN] or
[UP] switch.
- The tuning dial can also be used while [MEMO] is |
pushed.
@) Push [FUNC] then [MEMO-MrVFO] for 2 sec. to
transfer the contents of the memory channel.
- The contents are transferred to the most recently
used VFO (VFO A or VFO B).
Hi Memory clearing
Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels.
(@) Push [MEMO] to select the memory mode.
(2) Select a memory channel to be cleared with the
[DOWN] or [UP] switch.
(3) Push and hold [FUNC] then push [MW-M-CL] for
2 sec. to clear the contents.
- The programmed frequency and operating mode
disappear,
@ To clear other memory channels, repeat steps @
and @).
NOTE: Scan edge channels P1 and P2 cannot
e cleared.
4
'4
li Scan edge channels
Scan edge channels, P1 and P2, are located be-
tween the highest memory channel (initially 50) and
channel 1. When operating a programmed scan, the
scan operates between these programmed frequen-
cies.
Programming can be performed in the same manner
as other memory channels.
TRANSFERRING EXAMPLE
Operating frequency : 144.028 MHz/CW (MEMO 1S)
Previously used VFO :VFOA
Select memory
channel 19.
Programmed contents
are transferred.
After 2 sec., the
operating band is
shown.
Scan edge
channel! P1
Scan edge
channel P2