Pavone Systems DAT 700 Technical Manual page 10

OPERATIONAL FUNCTIONS - PEAK AND HOLD FUNCTIONS
The instrument continuously stores the peak weight value.
PEAK DISPLAY
This function is available only if the peak calculation function is enabled via the corresponding parameter in the
instrument setup menu. The peak display is indicated by the letter P on the left of the display.
SET
PEAK FUNCTION
In addition to display, the peak value can be used in the following functions:
FUNCTION
LOGIC
OUTPUTS
SERIAL
PORTS
ANALOG
OUTPUT
FREEZING OF WEIGHT ACQUIRED
It is possible to freeze the weight against a strain on the logic inputs if one of them is set in the HOLD mode.
pag. 10
SWITCHING (NORMAL) WEIGHT / PEAK DISPLAY
Peak display
DESCRIPTION
Set-points can be configured to have the peak value as a reference. (See the procedure for
configuring operation of logic outputs).
Peak value acquisition (peak hold) through CONTIN, AUTOM, DEMAND, SLAVE and MODBUS
protocols.
The value of the analog output can take the peak value (peak hold). (See
the analog output configuration procedure).
ZERO
SET
HOLD FUNCTION
Peak reset
Weight display
DAT700 Instrument User Manual