Safety Measures; Safety Precautions - SMC Networks HRZF010-WS Operation Manual

1.6 Safety Measures

1.6.1 Safety Precautions

While this system is protected by various safety measures including the safety interlocks, the
following basic safety precautions should be observed to assure further safe operations.
Follow the following instructions upon operation of this system.
Failure to follow the instructions can lead to personal injury or hazardous
accidents.
Flammable refrigerant (R454C) is used. Refer to the Repair
Manual/Owner's Guide before servicing this product. Follow all safety
precautions.
Do not use mechanical devices or other means to accelerate the defrosting
process other than those recommended by the manufacturer.
Do not handle this product by any means other than specified in this
Operation Manual; this can result in damage to the product or fire.
This product uses a slightly flammable refrigerant. In case of refrigerant
leak, provide sufficient ventilation. Also, please keep away from fire.
The appliance shall be stored in a room without continuously operating
ignition sources (for example: open flames, an operating gas appliance or
an operating electric heater.
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
Read and understand this manual thoroughly before operation of this system.
⚫
Before operating the system during maintenance, inform all personnel who are working in the
⚫
vicinity of the system to alert them of your action.
Use appropriate tools and follow proper procedures.
⚫
See "1.6.4 Protective Equipment" on page 1-17 to wear protective equipment properly.
⚫
Refer to your safety manual for emergency evacuation.
⚫
Use assistance to carry object over 20 kg.
⚫
Check that all parts and screws are returned to the pre-work conditions at the end of work.
⚫
Do not work when intoxicated or feeling ill. Accidents may occur if disregarded.
⚫
Do not remove a panel unless permitted in this manual.
⚫
Do not handle this product by any means other than specified in this Operation Manual.
⚫
The component parts shall be replaced with like components so as to minimize the risk of
⚫
possible ignition due to incorrect parts.
HRZF Series
DOC1046494-2
Chapter 1 Safety
1.6 Safety Measures
1-13