Overview / Display Type I Vs. Ii / Compliance / Warnings / Precautions - Page 1 Of 2 - Structural Concepts Reveal NR4847RSSV2 User Manual

OVERVIEW / DISPLAY TYPE I vs. II / COMPLIANCE / WARNINGS / PRECAUTIONS - PAGE 1 of 2

OVERVIEW
•
These Structural Concepts Reveal® cases are
designed to merchandise packaged products at
40°F (4 °C) or less product temperatures.
•
Cases should be installed and operated according to
this operating manual's instructions to insure proper
performance. Improper use will void warranty.
NSF/ANSI TYPE I vs. II ENVIRONMENTAL CONDITIONS
This unit is designed for the display of products in ambient
environmental conditions where temperatures and relative
humidity are maintained within a specific range.
•
NSF/ANSI Type I Conditions: Product is displayed in
store conditions with maximum ambient temperature of
75 °F (24 °C) and maximum relative humidity of 55%.
ATTENTION
CONTRACTORS
WARNING
ELECTRICAL
HAZARD
WARNING
KEEP
HANDS
CLEAR
•
•
COMPLIANCE
•
WARNINGS
•
This equipment MUST be installed in compliance with
all applicable NEC, federal, state and local
electrical and plumbing codes.
Risk of electric shock. Disconnect power before servicing unit.
CAUTION! More than one source of electrical supply is
employed with units that have separate circuits.
Disconnect ALL ELECTRICAL SOURCES before servicing.
Hazardous moving parts. Do not operate unit with covers removed.
Fan blades may be exposed when deck panel is removed.
Disconnect power before removing deck panel.
CAUTION! IF YOUR UNIT IS SELF-CONTAINED, YOU
MUST CHECK CONDENSATE PAN POSITION AND PLUG!
Water on flooring can cause extensive damage!
Before powering up unit, check and confirm that:
• Condensate pan is DIRECTLY UNDER condensate drain.
• Condensate pan plug is securely plugged into receptacle.
•
Overflow pan has plug connected to its box. Units with
optional Clean Sweep® MUST HAVE two plugs connected.
WARNING: This product can expose you to chemicals, including
Urethane (Ethyl Carbamate), which are known to the state of
California to cause cancer and birth defects or other reproductive
harm. For more information go to P65Warnings.ca.gov.
4
NSF/ANSI Type II Conditions: Product is displayed in store
conditions with maximum ambient temperature of 80 °F
(27 °C) and maximum relative humidity of 55%.
If you are unsure if your unit is classified as NSF/ANSI
Type I or Type II, see tag next to serial label on your case.
Performance issues when in violation of applicable
NEC, federal, state and local electrical and plumbing
codes are not covered by warranty. See below.
Please read these important warnings carefully as they
can prevent injury or death.
COMPLIANCE
WARNING
WARNING