Job Mode - Stel REVOLUTION 2500 CE Instruction Manual

It is possible adjust the t2 value from 0,1 to 10
seconds.
Pressing again the button
regulate the FINAL CURRENT, that is a value used
to fill the crater when welding aluminum. A good
starting point for the user here is 60%
It is possible adjust the t2 value from 0,1 to 10
seconds.
Pressing again the button
regulate the Burn Back Value.
It works like in MIG 2T/4T.
Pressing again the button
regulate the Post Gas Flow time.
It works like in MIG 2T/4T.
it is possible to
it is possible
it is possible
SETTINGS
From every welding mode, pressing the button
it is possible to go into the settings menu.
TRIGGER JOB FUNCTION
On the first four position of JOB LIST it possible to
activate the TRIGGER JOB FUNCTION.
This function allows to recall one of the first three
parameter of the JOB LIST with a quick pressure
of torch button.
For recall these parameters they must have a Pre
Gas time of 0,3 sec or more.

JOB MODE

This function is active only for the following welding
modes :
MIG 2T
MIG 4T
MIG 4TS
This function allows you to save and recall 8
welding parameters.
6947800020
35