Temperature Units (2.2.2); Fill Rate Limit (2.2.3) - Siemens SITRANS LR500 Series Operating Instructions Manual

Radar level transmitters

Table of Contents

Setting

Default

Note

Dynamic decimal places

Each setting for parameter "Units" has a default number of decimal places used to show the

process value on the local display. However, if the value is too large to show on the segment

display, the decimal places will be automatically adjusted to show the process value.

Note

Process value too large to display

In some cases, even with dynamic decimal places, it is possible that the process value will be too

large to show on the local display, "#####" shows instead.

If this occurs in a typical application:

• Adjust parameter "Units" so that a smaller value can be shown, e.g. use meters instead of

millimeters.

If this occurs in a custom application:

• Adjust parameter "Custom units" so that a smaller value can be shown, e.g. use tons instead

of pounds.

• Note that a change to custom units also requires a scaling adjustment (see Custom units

(Page 75)).

9.2.2.2