9.2.4.9
Upper fault current (2.4.9)
Sets Upper fault current in Non-safety mode.
Setting
Default
9.2.4.10
Fault current (2.4.10)
Defines behavior when Fail-safe is initiated.
Setting
Default
See Fault codes and corrective actions (Page 159) for a list of faults that initiate Fail-safe,
causing "Fault current".
9.2.4.11
Fail-safe loss of echo (2.4.11)
Defines fail-safe behavior when fail-safe loss of echo occurs and fail-safe LOE timer expires.
Setting
Default
9.2.4.12
Fail-safe LOE timer (2.4.12)
Sets amount of time loss of echo will persist before device enters fail-safe state.
Setting
Default
9.2.5
Volume (2.5)
Note
Menu visibility
This menu will not appear on device unless it is configured.
9.2.5.1
Vessel shape (2.5.1)
Sets vessel shape, and allows device to calculate volume in addition to level.
SITRANS LR500 series with mA/HART
Operating Instructions, 03/2024, A5E51099898-AA
20.0 to 22.8 mA
22.8 mA
Upper fault current
Lower fault current
Lower fault current
Hold
Fault current
Hold
0 to 720 s
100 s
Parameter assignment
Last valid reading
Value set in parameter "Fault current"
9.2 Setup (2)
123