Checking Engine Oil Level; Checking Transmission Fluid Level - Kubota LX2620 Operator's Manual

DAILY CHECK
1. Turn the key switch to "ON", check the amount of
fuel by fuel gauge.
2. Fill fuel tank when fuel gauge shows 1/4 or less fuel
in tank.
3. Use grade No.2-Diesel fuel at temperatures above
-10 ℃ (14 ℉). Use grade No.1-Diesel fuel at
temperatures below -10 ℃ (14 ℉).
4. After refueling, close the fuel tank cap tight enough.
(1) Fuel tank cap
Fuel tank capacity
ROPS
CAB
IMPORTANT :
• Do not permit dirt or trash to get into the fuel
system.
• Be careful not to let the fuel tank become
empty. Otherwise, air will enter the fuel system,
necessitating bleeding before the next engine
start.
• Be careful not to spill during refueling. If a spill
occurs wipe it off at once or it may cause a fire.
• To prevent condensation (water) accumulation
in the fuel tank, fill the tank before parking
overnight.
• Check to see if the fuel tank cap is tight enough.
• Before refueling, make sure there are no flames
around and remove static electricity.

3. Checking engine oil level

WARNING
To avoid personal injury or death:
• Stop the engine before checking the oil level.
1. Park the machine on a flat surface.
2. Check the engine oil before starting the engine or 5
minutes or more after the engine has stopped.
LX2620,LX2620SU
27 L (7.1 U.S.gals.)
32 L (8.4 U.S.gals.)
3. To check the oil level, pull out the dipstick, wipe it
clean, replace it, and pull it out again. Check to see
that the oil level lies within the crosshatched area.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See LUBRICANTS, FUEL AND COOLANT on
page 95.)
(1) Oil inlet
(2) Dipstick
IMPORTANT :
• When using an oil of different manufacturer
or viscosity from the previous one, remove
all of the old oil.
Never mix 2 different types of oil.
• If the oil level is low, do not run the engine.
• In adding engine oil, use a funnel or the like,
which could prevent the oil from getting
splashed on hot spots.

4. Checking transmission fluid level

1. Park the machine on a flat surface, lower the
implement and shut off the engine.
PERIODIC SERVICE
(A) Oil level is acceptable within
this range.
101