Telescopic Lower Links [Cab Model]; Drawbar; Adjusting Drawbar Length - Kubota LX2620 Operator's Manual

3-POINT HITCH AND DRAWBAR
2. After aligning satisfactorily, insert the set-pin
through any one of the holes on the outer tube that
align with one of the holes on the inner bar and both
stabilizers will be locked.
If the set-pin is inserted through the slot to engage
one of the holes on the inner bar, a limited degree
of sway will be permitted.
(1) Outer tube
(2) Inner bar
(3) Set-pin
(4) Hole
(5) Slot
7. Telescopic lower links [CAB
model]
To attach an implement, follow the instructions below:
1. Push the levers, pull out the lower link ends, and
attach to the implement.
2. Back up the tractor slightly to make sure the lower
links are pushed in securely.
(1) Lever

DRAWBAR

WARNING
To avoid personal injury or death:
72
(A) Push
(B) Pull out
• Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward.

1. Adjusting drawbar length

1. When towing an implement, it is recommended that
hole (A) in drawbar be utilized.
2. For information about the drawbar load, read the
implement limitations section of this manual.
(See IMPLEMENT LIMITATIONS on page 32.)
(1) PTO Shaft cap
(2) Drawbar
(3) Drawbar pin
THE 3-POINT HITCH SETUP
(A) Hole
(B) Hole
LX2620,LX2620SU