Table of Contents
Advertisement
PERIODIC SERVICE
Using fuel
Temperature
Above -10 ℃ (14 ℉)
Below -10 ℃ (14 ℉)
1. Turn the key switch to the on
the amount of fuel by the fuel gauge.
2. Fill the fuel tank with fuel when the fuel gauge
shows as follows.
Amount of fuel for refueling
Fuel tank capacity
(1) Fuel tank cap
3. Checking the engine oil level
WARNING
To avoid serious injury or death:
• Be sure to stop the engine before checking the
engine-oil-level.
IMPORTANT :
• When using an engine oil of different maker or
viscosity from the previous one, remove all of
the old engine oil and oil filter. Never mix 2
different types of engine oil.
• If the engine-oil-level is low, do not run the
engine.
Check the engine oil before starting the engine or 5
minutes or more after the engine has stopped.
1. Park the machine on a firm, flat, and level surface.
2. To check the engine-oil-level, draw out the dipstick.
3. Wipe the dipstick clean.
4. Replace the dipstick.
5. Draw the dipstick out again.
6. Check to see that the engine-oil-level lies between
the 2 notches.
78
fuel
Grade No.2-Diesel fuel
Grade No.1-Diesel fuel
position and check
1/4 or less in the fuel tank
25 L
(6.6 U.S.gals.)
7. If the engine-oil-level is too low, add new engine oil
to the prescribed level at the oil inlet.
(See
LUBRICANTS, FUEL, AND COOLANT TABLE
on page
73)
BX1880 and BX2380
BX2680
(1) Oil inlet
(2) Dipstick
4. Checking the transmission fluid
level
WARNING
To avoid serious injury or death:
• Park the tractor on a firm, flat, and level surface,
lower the implement to the ground, and shut off
the engine.
IMPORTANT :
• If the transmission-fluid-level is low, do not run
the engine.
1. To check the transmission-fluid-level, draw out the
dipstick.
2. Wipe the dipstick clean.
3. Replace the dipstick.
4. Draw the dipstick out again.
DAILY CHECK
(A) Engine oil level is acceptable
within this range
BX1880, BX2380, BX2680
Advertisement
Table of Contents
