Table of Contents
Advertisement
DAILY CHECK
Using fuel
Temperature
Above -10 ℃
Below -10 ℃
1. Turn the key switch to the on
the amount of fuel by the fuel gauge.
2. Fill the fuel tank with fuel when the fuel gauge
shows as follows.
Amount of fuel for refuelling
Fuel tank capacity
(1) Fuel tank cap
3. Checking the engine oil level
WARNING
To avoid serious injury or death:
• Be sure to stop the engine before checking the
engine-oil-level.
IMPORTANT :
• When using an oil of a different manufacturer or
viscosity from the previous one, remove all of
the old oil. Never mix 2 different types of engine
oil.
• If the engine-oil-level is low, do not run the
engine.
Check the engine oil before starting the engine or 5
minutes or more after the engine has stopped.
1. Park the machine on a firm, flat, and level surface.
2. To check the engine-oil-level, draw out the dipstick.
3. Wipe the dipstick clean.
4. Replace the dipstick.
5. Draw the dipstick out again.
6. Check to see that the engine-oil-level lies between
the 2 notches.
BX231D
fuel
Grade No.2-Diesel fuel
Grade No.1-Diesel fuel
position and check
1/4 or less in the fuel tank
25 L
7. If the engine-oil-level is too low, add new engine oil
to the prescribed level at the oil inlet.
(See LUBRICANTS, FUEL AND COOLANT on
page 84)
BX231D
BX261D
(1) Oil inlet
(2) Dipstick
4. Checking the transmission fluid
level
WARNING
To avoid serious injury or death:
• Park the tractor on a firm, flat, and level surface,
lower the implement to the ground, and shut off
the engine.
IMPORTANT :
• If the transmission-fluid-level is low, do not run
the engine.
1. To check the transmission-fluid-level, draw out the
dipstick.
2. Wipe the dipstick clean.
3. Replace the dipstick.
4. Draw the dipstick out again.
PERIODIC SERVICE
(A) Engine oil level is acceptable
within this range
87
Advertisement
Table of Contents
