The 3-Point Hitch Setup; Selecting The Holes Of Lower Links; Selecting The Top Link Mounting Holes - Kubota LX2620 Operator's Manual

3-POINT HITCH AND DRAWBAR

THE 3-POINT HITCH SETUP

1. Make preparations for attaching implement.
• Selecting the holes of lower links on page 70
• Selecting the top link mounting holes on page
70
• Drawbar on page 71
2. Attaching and detaching implements
WARNING
To avoid personal injury or death:
• Stop the engine and remove the key.
• Do not stand between the tractor and
implement unless the parking brake is
applied.
• Before attaching
implement, locate the tractor and implement
on a firm level surface.
• Whenever an implement or other attachment
is connected to the tractor 3-point hitch,
check the full range of operation for
interference, binding or PTO separation.
• Lifting rod (right) on page 71
• Top link on page 71
• Telescopic stabilizers on page 71
• Telescopic lower links [CAB model] on page 72

1. Selecting the holes of lower links

There are 2 holes in the lower links. For most
operations, the lifting rods should be attached to the (A)
hole.
[ROPS model]
(1) Lower link
(2) Lifting rod
70
or detaching the
(A) Hole
(B) Hole
[CAB model]
(1) Lower link
(2) Lifting rod
NOTE :
• The lifting rods may be attached to (B) hole for
greater lifting height.
2. Selecting the top link mounting
holes
Select the proper set of holes.
(See Hydraulic control unit reference chart on page
79.)
(1) Top link mounting hole 1
(2) Top link mounting hole 2
IMPORTANT :
• When storing the top link in its bracket, the top
link pin may damage the rear glass of the CAB.
Remove the pin from the hole at the end of the
top link and insert it in the unused top link
mounting hole.
THE 3-POINT HITCH SETUP
(A) Hole
(B) Hole
LX2620,LX2620SU