Lcd Monitor Message; Pto Shaft Cover And Shaft Cap; Stationary Pto - Kubota LX2620 Operator's Manual

PTO
2. Shift the lever to "ON" to engage the PTO clutch.
Shift the lever to "OFF" to disengage the PTO
clutch.
(1) PTO clutch lever
Engine speed
Shaft
PTO speed
NOTE :
• Tractor engine will not start if the PTO clutch
lever is in the engaged "ON" position.
• When you stand up from the seat with the
PTO clutch lever in the "ON" position, the
engine will stop regardless of the position of
the PTO select lever.
This is because the tractor is equipped with
an operator presence control (OPC) system.

4. LCD monitor message

1. The PTO rpm can be checked in the LCD monitor.
(See Changing display mode on page 58.)
Display switch "ON"
(1) LCD monitor
(2) PTO indicator
(3) PTO speed
66
(A) "ON" "ENGAGE"
(B) "OFF" "DISENGAGE"
2398 rpm
6-spline
540 rpm
NOTE :
• With the PTO in the "ON" position, a
numeric value is displayed on the LCD
monitor even if the PTO shaft is not turning.

5. PTO shaft cover and shaft cap

WARNING
To avoid personal injury or death:
• Keep the PTO shaft cover in place at all times.
Put back the PTO shaft cap when the PTO is not
in use.
• Before connecting or disconnecting a drive
shaft to the PTO shaft, be sure the engine is off.
Also, if a raisable PTO shaft cover is equipped,
raise the cover up to the raised position.
Afterward return the PTO shaft cover to the
normal position.
(1) PTO shaft cover
(2) PTO shaft cap
IMPORTANT :
• The universal joint of the PTO drive shaft is
technically limited in its moving angle. Refer to
the PTO drive shaft instructions for proper use.

6. Stationary PTO

To park the tractor and use the PTO system (for chipper
or pump, for example), start the PTO system in the
following steps.
1. Apply the parking brake and place blocks at the
tires.
2. Make sure the shift levers are at neutral, and start
the engine.
3. Set the PTO select lever to "rear PTO" position.
[except LX2620SU]
4. Push and hold the stationary PTO switch for more
than 1 second and the switch light will turn on.
PTO OPERATION
(A) "NORMAL" position
(B) "RAISED" position
LX2620,LX2620SU