Checking The Power Steering Line; Adjusting Toe-In - Kubota LX2620 Operator's Manual

PERIODIC SERVICE
1. Place the oil pan underneath the transmission oil
filter and remove the filter.
Do not remove the hydraulic oil filter. Otherwise, the
oil comes out.
(1) Transmission oil filter
2. Put a film of clean transmission oil on the rubber
seal of the new filter.
3. Quickly tighten the filter until it contacts the
mounting surface, then, with a filter wrench, tighten
it an additional 1 turn only.
4. After the new filter has been replaced, fill the
transmission oil up to the upper limit on the dipstick.
(1) Oil inlet
(2) Dipstick
5. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
6. Make sure that the transmission fluid does not leak
past the seal on the filter.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a Kubota genuine filter.
• Do not operate the tractor immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent
transmission.
112
(A) Oil level is acceptable within
this range
damage to the

4. Checking the power steering line

1. Check to see that all lines and hose clamps are
tight and not damaged.
2. If the hoses and the clamps are found to be worn or
damaged, replace or repair them at once.
(1) Power steering pressure hoses
(1) Power steering pressure hoses

5. Adjusting toe-in

(A) Wheel-to-wheel distance at the rear
(B) Wheel-to-wheel distance at the front
(C) "FRONT"
1. Park the tractor on a flat surface.
EVERY 200 HOURS
LX2620,LX2620SU