IBM Application System/400 Service Information page 55

A6xx, B6xx,C6xx, D6xx
(A6xx, 86xx, C6xx, D6xx) Vertical Licensed Internal Code (VLlC)
Reference Codes
Note: If the failing item is a failing item (FI) code, go to "Failing Item (FI) Code Table" on page 2-55 to
determine which part number associated with the FI code is failing. If the failing item is not an FI code, go
to the failing item table following this reference code table for a description of the failing item.
Reference Description/Action Failing
Code Perform all actions before exchanging Failing Items Item
0000
Operating system status code
This reference code is for information only. It is shown in the error log as a side
effect of a condition that was detected by VUC.
Normally, no action should be taken as a result of information reference codes.
However, to isolate the root cause, use these suggestions:
1. Examine the date and time of the informational reference code.
2. Determine if any other reference codes have been logged at or before the
same date and time.
3. Begin the service approach based on these other logged errors.
0101 to OS/400 licensed program failed AJDG301
010S
Perform "VUC-PIPS" on page 3-22.
0110 System equipment problem
Select Function 02 (start IPL) press Enter to start the IPL. This may cause a new
reference code. Use the new reference code to analyze the problem. If no refer-
ence code appears, the system has corrected the problem.
0115 System equipment problem AJDG301
Perform "VUC-PIPS" on page 3-22.
0116 System equipment problem
Select Function 02 (start IPL) press Enter to start the IPL. This may cause a new
reference code. Use the new reference code to analyze the problem. If no refer-
ence code appears, the system has corrected the problem.
0150 Operating system status code AJDG301
Perform "VUC-PIPS" on page 3-22.
0201 Not enough system storage for initial program load AJDG301
Perform "VUC-PIPS" on page 3-22.
0202 Operating system recovery needed
Restore the Licensed Internal Code using the "Licensed Internal Code Install and
Restore" procedures in the Service Functions User's Guide.
0204 Operating system recovery needed
Perform "VUC-PIP8" on page 3-22.
The problem may also be that there is not enough auxiliary storage.
0208 OS/400 licensed program failed
AJDG301
Perform "VUC-PIP8" on page 3-22.
0209, Operating system recovery needed
0215
Perform "VUC-PIP8" on page 3-22.
Chapter 2. Unit Reference Codes
2-29