IBM Application System/400 Service Information page 10

DANGER
To prevent a possible electrical shock when installing the system, ensure that the power
cords for all devices are unplugged before installing signal cables.
(RSFTD202)
DANGER
To prevent a possible electrical shock when adding or removing any devices to or from the
system, ensure that the power cords for those devices are unplugged before the signal
cables are connected or disconnected. If possible, disconnect all power cords from the
existing system before you add or remove a device.
(RSFTD203)
DANGER
To prevent a possible electrical shock during an electrical storm, do not connect or discon-
nect cables or station protectors for communications lines, display stations, printers, or
telephones.
(RSFTDOO3)
DANGER
To prevent a possible electrical shock from touching two surfaces with different electrical
grounds, use one hand, when possible, to connect or disconnect signal cables.
(RSFTD004)
DANGER
To prevent a possible electrical shock, do not use the port tester during electrical storms.
(RSFTD006)
Caution Notices
A caution notice indicates a hazard that could possibly cause minor personal injury.
Use the following caution notices throughout the guide:
CAUTION:
The battery is an alkaline battery. Do not burn or charge the battery. Discard the battery as
instructed by local regulations.
(RSFTC229)
Warning Notices
A warning notice indicates the possibility of damage to a program, device, system, or data.
viii
AS/400 9401 Service Information