Adapter Card; Chassis - IBM Application System/400 Service Information

Adapter Card
1
Power off the system. (See "Powering Off
and Powering On the System" on
page 5-2.)
2
Disconnect the cable attached to the
adapter card.
3
Open the card latch. Pull the card from the
slot.
Note: A card latch must be pressed
together to release it from its hold. Then it
can be opened to disengage the card.
4
Install the adapter card by reversing the
removal procedure.
This ends the procedure.
Chassis
Note: Set the system time and date after com-
pleting this procedure. (See "Setting the Date and
Time" on page 5-3.)
1
Remove the 9401 cover, see "Cover" on
page 4-6.
4-2
AS/400 9401 Service Information
2
Is there an adapter card installed in the
9401.
Yes No
Go to step 4.
3
Open the card latch.
Pull the card from the slot.
Install the card in the new chassis.
Note: A card latch must be pressed
together to release it from its hold. Then it
can be opened to disengage the card.
4
Remove all airflow cards. Install the airflow
cards in the new chassis.
5
Perform the following:
a. Remove the screws located on each
end of the plate.
b. Pull the plate up and away from the
chassis.
Note: Hooks are located at each
corner of the plate. The hooks fit into
slots in the chassis.
RV2N512-O