IBM Application System/400 Service Information page 43

Reference
Code
CD02,
CD03,
CDOD,
CD42,
CD53
CF01
CF16
CF60
FF01
FF03
FF04
FF05
Description/Action
Perform all actions before exchanging Failing Items
Tape unit detected incorrect request from the lOP.
Ask your next level of support for assistance.
Tape unit detected incorrect request from Vertical LlC.
Ask your next level of support for assistance.
Tape unit detected incorrect request from Vertical LlC.
Ask your next level of support for assistance.
The data format is incorrect; the tape cannot be read
See the System Operator's Guide, SC41-S0S2 ("Using Tapes and Diskettes," QIC
Formats, Data Cartridges, and Tape Unit Compatibility,.
Damaged cartridge detected or the tape unit failed
1. Remove the data cartridge and inspect it for the following conditions:
• The tape has run off one of the spools (the tape does not pass in front of
the mirror).
• The mirror is broken or skewed out of its normal position.
• The data cartridge belt is broken or damaged.
• The tape is not wound correctly on both spools.
• The tape is broken.
2. Exchange the data cartridge if it has one of the above conditions.
Note: If the tape has been broken in more than one cartridge, also exchange
the tape unit.
Cartridge removed; end-of-tape processing did not complete
Perform the following:
1. Insert the cartridge again.
2. Send a DSPTAP command to the drive and read through all the files recorded
on the tape.
3. If an error occurs, run the job again. If an error does not occur, the tape is
good.
Cartridge removed; end-of-tape processing did not complete
Perform the following:
1. Insert the cartridge again.
2. Wait until the tape status light goes off. If the light does not go off, enter the
check tape (CHKTAP) command and change the end-of-tape option (ENDOPT)
to *REWIND or *UNLOAD.
3. After the status light goes off, remove the cartridge. The tape is now ready for
storage.
Cartridge changed or device reset; processing not complete
Perform the following:
1. If a new cartridge was inserted, remove it and insert the last cartridge used.
Otherwise, keep the cartridge in the drive.
2. Wait until the tape status light goes off. If the light does not go off, enter the
check tape (CHKTAP) command and change the end-of-tape option (ENDOPT)
to *REWIND or *UNLOAD.
3. After the status light goes off, remove the cartridge. The tape is now ready for
storage.
Failing
Item
6343
FI00130
AJDG301
AJDG301
MHGTFOR
MHGTCAR
Tape unit
UHGUSER
UHGUSER
UHGUSER
Chapter 2. Unit Reference Codes
2-17