Vuc-Pip1 - IBM Application System/400 Service Information

4
Is the Display Missing Disk Units display or
the Suspend Missing Disk Units display on
the console, and are all of the reference
codes OOOO?
No Yes
Go to "VUC-PIP11" on page 3-24
and use cause code 0002.
This ends the procedure.
5
Does the IPL complete successfully?
No Yes
~ Go to step 8 of this procedure.
6
A different SRC occurred. Use the new
SRC to correct the problem (see
Chapter 2, "Unit Reference Codes" on
page 2-1).
This ends the procedure.
7
Exchange the chassis (see "Chassis" on
page 4-2).
If the problem occurs again, ask your next
level of support for assistance and report a
Licensed Internal Code problem.
This ends the procedure.
8
Perform the following:
a. Copy the main storage dump from disk
to tape (see "Copying Main Storage
Dump to Tape or Diskette" in the
Service Functions User's Guide).
b. Print the error log (see "Error Log
Utility" in the Service Functions User's
Guide).
c. Copy the 1/0 processor dump from disk
to tape or diskette. Use the instructions
for the dump to tape function (see
"Copying the lOP Storage Dump to
Tape or Diskette" in the Service Func-
tions User's Guide).
Note: You need two tapes for these
dumps: one for the main storage dump and
one for the lOP dump.
3-22
AS/400 9401 Service Information
9
Ask your next level of support for assist-
ance and report a Licensed Internal Code
problem.
This ends the procedure.
vue-PIPs
Vertical Licensed Internal Code has detected
either an operating system program failure or a
hardware failure.
1
Perform the following:
a. Select IPL type A, mode M (see
"Selecting I PL and Mode" on
page 5-2).
b. Select Function 03 (Start IPL) and
press Enter on the control panel to
perform an IPL.
Does the same system reference code
(SRC) occur?
No Yes
~ Go to step 6 of this procedure.
2
Does the same unit reference code (URC)
appear on the console (see 'VUC PIP
Display Examples" on page 3-30)?
No Yes
~ Go to step 5 of this procedure.
3
Does a different SRC occur, or does a dif-
ferent U RC appear on the console?
No Yes
~ Use the new SRC to correct the
problem (see Chapter 2, "Unit Ref-
erence Codes" on page 2-1). If the
procedure for the new SRC sends
you back to this procedure, go to
step 5.
If all of the reference codes on the
console are 0000, go to
'VUC-PIP11" on page 3-24 and
use cause code 0002.
This ends the procedure.