IBM Application System/400 Service Information page 129

6
Are there main storage cards installed on
the system processor card?
Yes No
~
Go to step 9.
RV2N511-1
7
Warning: The system processor card and
main storage cards are sensitive to
electrostatic discharge. (See Appendix A,
'Working with Electrostatic Discharge-
Sensitive Parts" on page A-1.)
To remove a main storage card, perform
the following:
a. Push outwaJd on the latches located at
each end of the card.
b. Pull the card from the card socket and
place it on an ESD mat.
Note the location of the notch
E1
on the
storage card. You will need to install the
storage card in the socket with the notch in
the same position.
Repeat this step for each of the main
storage cards you want to remove.
.
...
~
RV2B632·1
8
Install the main storage cards in the new
chassis by reversing the removal proce-
dure.
Do not install the metal plate at this time.
Note: When installing the cards, place a
card in the socket. Push the top edge of
the card toward the system processor card
until the card latches in the socket.
9
Grip the battery holder clip at both ends
and press in. Remove the holder from the
chassis.
Chapter 4. Removal Procedures
4-3