IBM Application System/400 Service Information page 148

d. Select the Work with disk unit recovery
option from the Work with Disk Unit
display.
e. Select the Disk unit problem recovery
procedures option from the Work with
Disk Unit Recovery display.
f. Select the disk unit on the display that
is not configured.
g. Select the Initialize and format disk unit
option from the Disk Unit Problem
Recovery Procedures display. When
the new disk unit is initialized and for-
matted, the display shows that the
status is complete (this may take 30
minutes or longer).
h. Press the Enter key.
33
In this step, you use the ASP, unit, serial
number, type, and address information you
recorded in step 20 of this procedure.
Perform the following:
a. Return to the Work with Disk Units
display.
b. On the Work with Disk Units display,
select the Work with disk configuration
option.
c. Select the Work with ASP configuration
option.
d. Select the Add units to existing ASP
option.
e. Select the ASP that the disk units were
removed from.
f. Select the unit to add to the ASP.
g. When the Confirm Add Units display
appears, press the Enter key to con-
tinue. Wait for the next display.
34
The Add Disk Units function takes several
minutes. When it is complete, a message
appears stating whether it was successful.
Was the Add Disk Units function suc-
cessful?
Yes No
~
Ask your next level of support for
assistance.
This ends the procedure.
35
On the Work with ASP Configuration
display, select the Display disk configura-
5-12
AS/400 9401 Service Infonnation
tion capacity option. The unit you added
should be shown in the correct ASP.
This ends the procedure.