Table of Contents
Advertisement
10. Position front cover assembly lining up alignment pins in lower flange to the slots in the
electronics left assembly.
Slot
11. Rotate the front cover to vertical, being careful not to allow any cables to interfere between
the electronics along the top edge of the front cover. The magnets should engage, holding
the cover in place. The cover should look aligned and symmetric. If the cover is bulging or
does not appear to be fitting properly, remove it and adjust the cables that may be causing
the issue.
Planar UltraRes L Series 109" User Manual
020-1434-00A
55
Pin
Page | 55
Advertisement
Table of Contents
