Table of Contents
Advertisement
10.8 Powering up and Test Display
1. Connect main power cord to the left electronics box AC inlet.
2. Connect a video source to an HDMI input.
3. Connect main power cord to 110V wall outlet and turn on main power switch next to the
AC inlet.
Caution:
Exposed power supplies in the electronics box has hazardous voltage. Be
careful not to touch any parts in the exposed electronics area.
4. Verify that the splash screen appears in middle of display. Use the remote to browse to
the Test Pattern menu and select white to verify the image is shown on all LED modules
installed in the display.
5. If all modules displayed successfully, turn off the power switch and proceed with the next
assembly procedure. If all the modules did not display correctly, see the "Troubleshooting"
section on page 144.
Planar UltraRes L Series 109" User Manual
020-1434-00A
49
Page | 49
Advertisement
Table of Contents
