Planar UltraRes URL109-MFT User Manual page 27

6. Noting the orientation of threaded holes along the right wings lower face, place the end of
the right wing over the lower hole pattern on the top of the vertical column engaging the
alignment pins between the parts as shown.
Alignment Pins
Under Flange
Lower Hole
Pattern
7. Noting the orientation of threaded holes along the right wings lower face, place the end of
the second right wing over the lower hole pattern in the middle the vertical column as
shown above.
Planar UltraRes L Series 109" User Manual
020-1434-00A
27
Threaded Holes
Orientation
Threaded Holes
Orientation
Right Wing
Page | 27