Table of Contents
Advertisement
9. Adjust the jack screws installed in step 7 to create an even vertical spacing. The pixel
spacing between columns should look like the pixel spacing within a module for best
results. After adjusting the jack screws, check the vertical alignment done in step 8 and
correct if needed.
10. Repeat steps 7 through 9 for column 3.
1
2
11. If installing into an inset, see "Last Column Installation in Recess" on page 64 before
continuing. Column 4 requires all edge guards be removed before hanging on the mount
bars. Make sure that both top and bottom far right hanger brackets are hooked on the
mount bars, and slide column 4 in contact with column 3.
Caution:
Do not slide the column to the right or the column may fall off the mount bars,
causing injury and/or product damage.
1
2
Planar UltraRes L Series 109" User Manual
020-1434-00A
37
3
3
4
Page | 37
Advertisement
Table of Contents
