Table of Contents
Advertisement
8. Slightly pull the bottom of the left side trim away from the side of the display to gain access
to the touch flex cables. Connect the left side touch flex cable to the mating connector,
aligning the ends of the flex cables as shown in step 6. Carefully store the excess cable
into the open area of the trim and front cover. Next move the left side trim back to its
original position against the magnets on the side of the display, being careful not to pinch
the cable. Repeat the touch cable connection at the bottom of the right side trim using the
same procedure.
Left Side Trim
9. Install (2X) M3 x 6 FHMS BLK through the bottom flange of the electronics assembly to
secure the bottom of the side trim pieces as shown.
10. Install the modules that have been removed from the display. See step 3 on page 63.
Planar UltraRes L Series 109" User Manual
020-1434-00A
60
Page | 60
Advertisement
Table of Contents
