Planar UltraRes URL109-MFT User Manual page 36

7. Remove column 2 from the packaging. After removing column 2's left edge guard, hang
the column on the mount bars. Remove the remaining edge guards and gently slide to the
left against column 1. Attach the jack screw brackets as in step 5 and adjust the jack
screws, creating a vertical thin gap between the columns. The gap should be small
enough to perform the next step. Do not over tighten the jack screws; it may prevent the
following alignment steps.
Note: Having a gap that is not even the entire length of the column may result in having to
repeat step 8. The pixel spacing between columns should look like the pixel spacing within
a module for best results.
1
2
8. To vertically align columns, use the column alignment plates. When two columns are
installed next to each other determine which column needs to be raised to correct
alignment. Place the thick side of the column alignment plate on the column to remain
fixed in place and install a M4 X 10 FHMS screw. Install another M4 X 10 FHMS screw
through the thin side of the column alignment plate into the other column and tighten until
the pixels are in horizontal alignment with the fixed column. It may be beneficial to help
raise a column by lifting from the bottom as the screw is being tightened.
Higher Column
Planar UltraRes L Series 109" User Manual
020-1434-00A
36
Thick Side
M4 X 10 FHMS
Thin Side Lower Column
Page | 36