Table of Contents
Advertisement
10.2 Assembling Rolling Floor Stand
If mounting to a structure skip to the "Preparing the Wall for Wall Mounting" section on page 31.
1. The rolling floor stand can hold the display at two heights, 2066mm (81.3") and 2166mm
(85.3") from the ground. The following procedures show the lower rolling floor stand
assembly. If mounting the desired height of 2166mm (85.3"), use the hole patterns labeled
with 800 instead of 700 where appropriate.
Note: The rolling floor stand has adjustable casters to maintain the level of the display.
When assembling, be sure they are fully tightened to the stand. When adjusting, the
maximum distance of adjustment from fully tightened of any wheel should be about 0.20"
(5mm) or approximately 3 full rotations of the adjustment wrench.
Caution:
When moving the display between locations, it is highly recommended to avoid sharp
changes in the surface and soft surfaces like plush carpet.
Do not use excessive force to move the display. When moving a display, grip and
apply force to the stand, not the display.
It is suggested to move the unit on the floor stand over long distances with the narrow
edge leading to ease movement.
Planar UltraRes L Series 109" User Manual
020-1434-00A
23
Page | 23
Advertisement
Table of Contents
