Table of Contents
Advertisement
How the Honda Robotic Lawnmower works
1
OVERVIEW
How the Honda Robotic Lawnmower works
The mowing area is determined by the boundary wire that emits a signal; when the
lawnmower detects the boundary it turns and it cuts the grass randomly. When battery
starts running out, it goes back to the docking station.
Pegs
Boundary wire
Lay the boundary wire by burying it under the ground, or
securing it on the ground with pegs.
Maximum area: 4000 m²
Maximum possible length: 1000m
4
If Mii-monitor is installed on a smartphone connected to mobile network, you
can configure settings and check error notifications from any remote location.
AC adapter
The AC adapter must be installed in a shaded area protected from rain.
Install and fix the AC adapter on the wall at a minimum height of 30cm from the ground.
Connect the AC adapter to the power supply after all connections are completed.
Docking station
The docking station should be placed on level ground,
and the height difference between the front and back of
the docking station should not exceed 5°. For details, see
"Installation" (M page 15).
Power cord
Robotic Lawnmower
Free zone
Use GPS to set areas where you want to reduce the frequency of the
lawnmower intrusion (for planned activities or if the user requires an
area to continue to grow).
For details, see "GNSS" (M page 53).
There are various ways to install the
docking station. For details, see "Checking
conditions for installation" (M page 15).
Shortcut wire
The Shortcut wire is laid in the ground or
fixed to the ground with wire pegs.
Lay the shortcut wire at a bending angle
of 90° or more.
Advertisement
Table of Contents
