Honda HRM4000EC Owner's Manual page 25

Installation
Installing boundary wire and connecting to the docking
station
Connector
Connector(S1)
Connector(AR)
22
Image
Boundary wire
–
Depth: 1 20 cm
Connector(S2)
Tab
Set the boundary wire by using the "LAWN
DIAGRAM" (M page 109).
• Leave enough wire to ensure that small
adjustments can be made, double backing
outside of the loop is acceptable.
• Do not fix the wire until finish the layout.
• The boundary wire should be laid so that there
is no excess wire.
Peg
Fix the boundary wire with pegs to the specified
depth as shown.
Attach a connector to both ends of the boundary
wire.
1. Put the boundary wire in the grip area of the
connector.
2. Press the connector click with a plier.
3. Cut the position of 1-2 cm from the each
connector.
The boundary wire must not be crossed when
connecting to the docking station.
Attach each wire to the station's connector
according to the instructions on the label
attached to the station.
Boundary wire left side: AL
Boundary wire right side: AR
Shortcut wire 1: S1
Shortcut wire 2: S2
1. Remove the station cover (M page 77).
2. Pass the boundary wire and the shortcut
wires through the tabs as shown.
3. Insert the connectors into the pins.
4. Install the station cover.
Connector(AL)
NOTE:
- To connect the AC adapter to the docking
station (M page 77).
Operation